Racelogic USER GUIDE Manual de usuario descargar pdf (Pagina 7)

Page | 7 Revision 1.4 15 January 2015

Quick start guide

In addition to this guide, a short LabSat 3 Quick Start video is available on the LabSat 3 SD card and also on

the LabSat 3 HDD.

Example of Replay - using the included SD card with preloaded scenario.

Briefly press the power button to power up the LabSat 3. Connect from the RF output on the rear of the

LabSat 3 to your GPS system antenna input. With the SD card inserted, use the UP/DOWN arrows to select

a file. Press the PLAY button to start replay.

LabSat 3 contains an on board GNSS receiver that allows monitoring of the RF signals during record or

replay. To show a live histogram of satellite signal levels detected by the on board receiver, press the OK

button during replay. Press the OK button again to return to the replay status display. During replay,

pressing the PLAY button will halt replay and return to the file list.

Example of Record – Recording your own file to an SD card (RP variants only)

To record a new file, connect the LabSat 3 antenna to the RF input on the rear of the LabSat. Ensure that

the antenna has a clear view of the sky, press the REC button to start recording. Press the REC button again

to stop recording. While recording, if the SD card becomes full, recording will stop automatically. During

recording, pressing the OK button will switch the display to show a live histogram view of the satellite levels

being received by the on-board GNSS monitor. Pressing the OK button again will return to the record

status display.

During recording, while using battery power, the GNSS monitor display will automatically revert to the

record display after a short period to conserve battery power. This power save feature can be switched off

but it is recommended to be left active for maximum battery life.

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

Sin comentarios

Racelogic USER GUIDE Manual de usuario Pagina 7