Racelogic USER GUIDE Manual de instrucciones descargar pdf (Pagina 17)

Revision 13 Page 17 of 35

Replaying GPS Data with LabSat

NB: Applicable to RLLSP01 and RLLSR01 LabSat Models.

Any LabSat unit can replay a recorded scenario file to any connected GNSS device capable of receiving the L1 GPS/Galileo signal.

NB: LabSat is designed for direct connection to a GNSS receiver via a suitably screened cable. If testing is to be performed on GNSS equipment

without an external antenna connection, it is the responsibility of the user to ensure that this is done in a fully RF screened environment.

Contact Racelogic for more information.

The LabSat is connected as illustrated in the diagram below:

1. Connect power to the LabSat, and the recipient GNSS device.

2. Connect the high speed USB (A to B) and USB serial cable from the LabSat to

the computer the Scenario data file will be replayed from.

3. The LabSat comes supplied with a number of adaptor cables which allow

connection to a number of GNSS devices. Select the appropriate antenna cable

for the device to be connected.

4. Connect the RF-Out connector of the LabSat (illustrated Right) to the GNSS

antenna input of the device.

5. Start the LabSat software.

6. The LabSat is now ready to replay GPS/Galileo data to the DUT (Device Under Test). Select the Replay Mode tab on the LabSat (See below). The

LabSat is now ready to replay GPS/Galileo RF data.

7. Once the GNSS device is powered and ready to receive data, press the Browse button to locate and select the scenario required for the test. The

Info button will display a summary of the scenario.

8. Click the Play button to start scenario replay on LabSat.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Sin comentarios

Racelogic USER GUIDE Manual de instrucciones Pagina 17