Racelogic USER GUIDE Manual de instrucciones descargar pdf (Pagina 23)

Revision 13 Page 23 of 35

Converting LabSat 2 Scenarios to run on LabSat

LabSat uses a binary Intermediate Frequency, to down convert GPS RF data into a binary file, whereas LabSat 2 stores GNSS RF data as an IQ binary file.

This means that existing LabSat scenarios cannot be run natively on a LabSat 2 or vice versa.

Racelogic has therefore developed a conversion utility which allows LabSat users to perform a one-time conversion of existing LabSat 2 scenarios into the

LabSat *.bin format or LabSat scenarios into the LabSat 2 *.ls2 format. The conversion utility is provided with the LabSat software and provides for automatic

conversion of LabSat scenario files. The operation of the conversion utility is shown, below.

Clicking the browse button beside Source Scenario allows you to specify the

existing LabSat scenario for conversion. LabSat scenarios have the file

format: Filename.bin and LabSat 2 scenarios have the file format:

Filename.ls2.

The LabSat Scenario Converter tool will automatically convert the existing

LabSat scenario, Filename.bin into a LabSat 2 scenario, Filename.ls2 or

existing LabSat 2 scenario, Filename.ls2 into a LabSat scenario

Filename.bin.

The new scenario will be automatically saved in the same location on the PC

as the existing Source scenario. It is possible to specify a different location

and filename by clicking the browse button beside Destination Scenario, on

the LabSat Scenario Converter

A new LabSat converted scenario can be run on a LabSat GNSS simulator. This new scenario contains only GPS L1 RF data. The RF data for GLONASS

L1 is not created by the LabSat Scenario Conversion tool

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Comentarios a estos manuales

Sin comentarios

Racelogic USER GUIDE Manual de instrucciones Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Navegadores Racelogic USER GUIDE