Racelogic USER GUIDE Manual de usuario descargar pdf (Pagina 51)

RACELOGIC Traction Control Manual V3.0

Page 51

3.5 Rev limits

Moving rev limiter

Soft cut / Hard cut

Similar to the rev limits used for the Launch Control Function except these are

operated whilst the car is moving. Again, the soft cut is operated at, say 5500

RPM and the hard cut is operated at a higher engine speed, say 5750 RPM.

These rev limits are used for the Power Shift function. It is activated by the

clutch switch, and allows full throttle gearshifts to be carried out whilst the

engine is prevented from over-revving.

Default value: Soft cut 65535 RPM , Hard cut 65535 RPM.

Note: a value of 65535 will set this function to OFF.

Clutch switch

The polarity of the clutch switch is normally open, which is closed when the

clutch pedal is depressed. If a normally closed switch is used, i.e. one that

breaks connection when the clutch is depressed, tick the box.

Default value: enabled

Soft / Hard rev-limit settings

Placing a

will allow an injector to fire, putting a will prevent the injector

from firing.

To quickly set all to either fire or non-fire use the appropriate icon in the ‘Set all to’.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 66 67

Sin comentarios

Racelogic USER GUIDE Manual de usuario Pagina 51