Racelogic USER GUIDE Manual de usuario descargar pdf (Pagina 67)

RACELOGIC Traction Control Manual V3.0

Page 67

8. Spark cut

8.1 General

The spark cut traction control unit, works by monitoring the signal used by the coil too

generate a spark. If traction control is required this signal is interrupted so that

individual firing pulses are selectively missed out resulting in a reduction of engine

power.

8.2 Connecting the spark cut

Locate the negative side of the coil(s). Generally a coil will have two terminals, a

positive which will show a constant +12V and a negative which carries the signal that

the coil will amplify.

The traction control has two coil interface wires (pins 12 and 13). For a single coil

application join both these wires together and attach to the negative side of the coil.

For a twin coil application use both wires separately.

For spark cut sequential mode must be selected (Configuration tab).

8.3 RPM

No external RPM signal is required.

Note: the cylinder value in the traction control may need to be adjusted to get the

correct RPM reading.

1 2 ... 62 63 64 65 66 67

Sin comentarios

Racelogic USER GUIDE Manual de usuario Pagina 67