Racelogic USER GUIDE Manual de usuario descargar pdf (Pagina 65)

RACELOGIC Traction Control Manual V3.0

Page 65

6.2 Setting the Clutch Switch REV Limits

These rev limits are similar to the rev limits used for the launch control function

except they are operated whilst the car is moving. The difference between the soft

and hard cut is set to 250 Rpm.

The rev limits will need to be set 1000-500 Rpm lower than the cars own rev limit.

The full throttle shift should be smooth, so adjust the rev limits to get the smoothest

change.

6.3 Testing the Clutch Switch

The easiest way to test the switch is to drive the car on a quiet road. While still rolling

place the car into neutral, press the clutch and raise the revs up to the new rev-limit.

By placing the accelerator hard down the car will settle on the new rev-limit, until the

clutch is released.

1 2 ... 60 61 62 63 64 65 66 67

Sin comentarios

Racelogic USER GUIDE Manual de usuario Pagina 65